Product Manual

Page 6 of 12
floor before leaving unattended.
 Never raise the furniture more than once inch off the floor.
 Always plan your route before moving furniture.
 Avoid any sudden movements.
Operating Instructions
⚠WARNING
 The floor must be level, smooth, clean, and free of inclines and slopes. Make sure that the floor
and the floor covering are built to hold the weight of the furniture and the mover.
 Secure or remove any loose objects that could cause the furniture to slope or tip while being
moved.
 Before transporting any furniture, wind the platforms down to the floor so the units are standing
vertically.
 Push the platform of the mover under both ends of the furniture.
 If the furniture has an overhang that interferes with the upper support, make sure that the upper
support is adjusted before moving the piece. To adjust the upper support, screw it in until the
support stands level.
 The center of the platforms on the units should be placed so that they are directly underneath the
furniture’s center of gravity. Failure to do so could result in the furniture tipping over or coming off
the platforms.
 Make sure that the upper and lower supports sit tightly against the furniture.
 Place the securing straps so that they are tight against the edge protectors.
 Pull the straps tight. When used correctly, the straps should connect both units and prevent them
from slipping out of position.
 Wind the platforms so that the furniture is about 1/2" off the floor. (Both platforms should be raised
an equal amount.) Raise the platforms by turning the crank clockwise, counter-clockwise to lower
the platforms.
 Once raised, check to make sure that the furniture sits firmly on the platforms.
 Move the furniture. Always push the units and not the furniture when moving.
 Lower the furniture to the floor before releasing the securing straps.
Maintenance
⚠WARNING
Regular maintenance is recommended to keep the mover in good working condition.
Maintain the mover by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep the mover in good repair.
 The spindles should be greased on a weekly or monthly basis, depending on usage.
 Use standard multi-purpose grease.