Product Manual

Page 5 of 12
⚠CAUTION
MOVER USE AND CARE
 Use only accessories that are recommended by the manufacturer for your mover. Accessories
that may be suitable for one tool may create a risk of injury when used on another tool.
 Do not force the mover. Products are safer and do a better job when used in the manner for which
they are designed. Plan your work, and use the correct product for the job.
 Check for damaged parts before each use. Carefully check that the mover will operate properly
and perform its intended function. Replace damaged or worn parts immediately. Never operate the
manual mover with a damaged part.
 Store the mover when it is not in use. Store it in a dry, secure place out of the reach of children.
Inspect the tool for good working condition prior to storage and before re-use.
 Position the supports on the narrow side (lengthwise) of the furniture being moved when possible.
Assembly Instructions
Each unit consists of three separate components: the frame, the platform, and the lifting mechanism.
 Remove the platforms from the box, and place them on the floor.
 Insert the spindle mechanism through the upper opening and the slot in the profiled guide rail,
until the locating projection is seated in the top of the guide rail. The upper side support and the
crank of the mechanism must face opposite directions. Do not tighten the clamping screw of the
guide rail yet.
 Slide the frame’s guide rail over the upper sliding insert of the platform.
 Insert the spindle through the hole until the frame is standing on its wheels. The gear housing will
be pushed out of the guide when the spindle contacts the lower sliding insert of the platform.
 Turn the crank clockwise to move the threaded spindle down through the lower insert, until the
locater of the gear housing is again seated in the guide and the bottom of the housing is resting
on the guide.
 Tighten the clamping screw.
Specific Operating Warnings
⚠WARNING
 Do not exceed loading capacity.
 Only use on a hard level surface.
 Ensure the load is secure by load constraining straps before moving.
 Do not use the if the height of the furniture exceeds 32 inches or if the units are less than 20
inches apart or more than 157 inches apart.
 Check both units for damage before operating the mover. If there are visible defects, do not use
the machine. Have any damaged parts replaced by a qualified service provider.
 Do not operate when the supports are not completely vertical.
 Do not leave furniture unattended while raised up on the unit. Always lower the furniture on to the