Product Manual

Page 7 of 22
Reference
Subassembly
6
Handle
Assembly Instructions
⚠WARNING
 TO PREVENT SERIOUS INJURY AND DEATH: Wear ANSI Z87.1 compliant safety goggles, hard
hat, heavy-duty work gloves, and steel-toed work boots during assembly and operation.
 The correct bolts must be used during assembly. If any doubts arise regarding proper assembly,
contact Northern Tool + Equipment before use.
Assembly Set-up
1. More than one person will be needed for assembly.
2. Use a large, clean, and uncluttered area for assembly.
3. Consider vertical clearance when choosing operation area. Assemble close to operation area.
4. Use saw horses (not included) to support larger items such as Posts and I-Beam during assembly.
5. The Post Insert (7) and Post Sleeve (3) are pre-assembled.
Assembly Instructions
Attaching Posts and Connector Plate A & B to I-Beam
(21) Bolt M12 x 35 (22) Washer 12 (23) Nut M12 (24) Spring Washer 12
1. Lay I-Beam (8) on the ground. Lay left and right Post Assemblies on the ground.
2. Attach Left Post Insert (7) to I-Beam (8), using Bolts (21), Washers (22), Nuts (23) and Spring
Washer (24). Each Bolt (21) needs 2 washers (22) to attach.
3. Tighten connections securely
4. Repeat for Right Post Assembly.