Product Manual

Page 15 of 22
 Always have a least 2 people operating crane at any time.
 Operate on a hard, level surface.
 Do not operate crane if the beam is not level.
 Do not use to lift people or animals.
 Keep persons and property clear from under the load.
 Do not allow the load to swing or roll against the support members.
Applying the Load
1. Attach the load to the load hook securely by properly rated, suitable means, such as chains,
shackles, hooks, lifting slings, etc. Load must be attached to prevent accidental disconnection.
2. Properly seat the sling or other device in the base (bowl or saddle) of the hook (Figure L). Do
not allow the hook hitch to support any part of the load.
3. Do not apply the load to the point of the hook (Figure L).
4. Do not operate the crane unless it is centered over the load.
5. Do not pick up a load in excess of the rated load appearing on the crane or load block, except
during properly authorized tests. Do not use a crane overload limiting device to measure the
maximum load to be lifted.
6. Give specific attention to load balancing and hitching or slinging to prevent load slipping.
Moving the Load
1. Do not engage in any activity which will divert the operator’s attention while operating the crane.
2. Respond to signals from a designated people only.
3. Do not lift or lower a load with the crane until the operator and all other people are clear of the
load.
4. Make sure the load and crane will clear all obstacles before moving or rotating the load.
5. Do not lift a load more than a few inches until it is well balanced in the sling or lifting device.
6. Each time a load approaching rated capacity is handled, check crane brake action by lifting the
load just clear of supports and continuing only after verifying that the brake system is operating
properly.
⚠WARNING
 Do not use to lift people or animals.