Product Manual

10
OPERATION
RAISING THE JACK
1. Position the jack near desired lift point.
2. Assemble the handle, ensure that handle aligns with handle socket.
3. Close the release valve by turning it clockwise until it is firmly closed.
4. Before raising check and verify the load is centered and also has full contact with the lifting point.
5. Pump handle or squeeze air trigger to lift to desired lifting height. (To stop air operation, simply release
the grip on the lift control valve.) Continue to pump the jack handle to lift the vehicle to the desired height.
After lifting, support the load appropriately before starting work.
WARNING: STOP PUMPING WHEN THE RAM RISES TO THE RED STOP MARK ON THE RAM.
THIS WILL PREVENT THE JACK FROM POSSIBLE MALFUNCTION AND IMPROPER USE.