Product Manual

9
BEFORE USE
1. Before using this product, read the owner's manual completely and familiarize yourself thoroughly with the product
and the hazards associated with its improper use.
2. Perform the air purge procedure. (See previous instructions for system purge procedure.)
3. Pour a teaspoon of good quality, air tool lubricant into the air supply inlet of the lift control valve. (See illustration)
Connect to air supply and operate for 3 seconds to evenly distribute lubricant.
4. Check and that the pump operates smoothly before putting into service.
5. This product is fitting use standard 1/4" NPT air fitting. If changing the fitting is required, install a 1/4" NPT fitting of
your choice, ensure that thread tape or compound is used to seal connection.
6. Inspect before each use. Do not use if bent, broken or cracked components are noted.
OPERATION
RAISING THE JACK
1. Position the jack near desired lift point.
2. Assemble the handle, ensuring that handle aligns with handle socket.
3. Close the release valve by turning it clockwise until it is firmly closed.
4. Before raising check and verify the load is centered and also has full contact with the lifting point.