Product Manual

Page 11 of 14
Interference
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
There is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. Consult experienced radio/TV technician for help.
Maintenance
Always unplug and disconnect the charger before performing maintenance on the unit. After each
use, use a dry, lint-free cloth to clean any battery corrosion or dirt from the clips, cords, and charger.
Ensure that all components are in good working order. Never open the charger as there are no
serviceable parts inside the unit. The charger should be stored in an upright position when not in use.
Store the unit in a cool, dry location.
Troubleshooting
Use the table below to troubleshoot problems before contacting service personnel or your local
dealer. If the problem continues after troubleshooting, call your local dealer for assistance.
Indicator
Possible Cause
Corrective Action
Flashing Red LED
The charger may not be properly connected
the battery or short circuit.
Check and reconnect the alligator clips or
ring terminals to the battery terminals.
Solid Red LED
Reverse polarity is occurring.
Check and correct the connection.
No color showing
The charger is not connected properly to the
AC power.
Make sure the AC outlet power is ON.
Parts List
Reference
Part Number
Part Description
Quantity
Image
1
56765-01
Charger
1
2
56765-02
Ring Terminals Cable
1
3
56765-03
Cable Clamps
1