Product Manual A

Page 8 of 12
Troubleshooting
Use this table to troubleshoot problems before contacting customer service. If the problem continues
after troubleshooting, call your local dealer for assistance.
Failure
Possible Cause
Corrective Action
The bead breaker won’t
catch and hold the steel
ring tightly.
 The steel ring is too large.
 The wheel has too much
pressure inside.
 This bead breaker is only suitable
for steel rings smaller than 26
inches. Replace with the correct
size.
 Release some of the pressure in
the wheel.
The bead breaker does
not work continuously.
 The hydraulic system is
leaking.
 Check the connection and
reassemble to be sure there is not
an oil leak.
The bead breaker does
not work.
 The hydraulic circuit
disconnects or the quick
coupling pipe is not
assembled correctly.
 There is not enough
hydraulic fluid in the air-
driven hydraulic pump.
 The air-driven hydraulic
pump doesn’t work.
 Check if the hydraulic circuit, quick
coupling, air-driven hydraulic
pump, and bead breaker connect
well.
 Check if the oil pipe matches the
quick coupling.
 Reassemble the hydraulic system
to be sure there is no oil leak.
The bead breaker won’t
lock tightly to push
normally.
 There is not enough
hydraulic fluid in the air-
driven hydraulic pump.
 Parts leak oil or are blocked.
 Add hydraulic fluid.
The bead breaker works
but there is not enough
push pressure.
 Air pressure from the
compressor is low, or the
air-driven hydraulic pump is
broken.
 It leaks oil.
 Check the pressure of the air
compressor, or check the air-
driven hydraulic pump, to be sure
it’s operating well.
The bead breaker leaks
oil.
 Sealed parts are worn or
damage.
 Change the seal parts.
The push rod or claw of
bead breaker can’t
retract completely.
 The quick coupling or oil
pipe is blocked.
 There is too much fluid oil in
the air-driven hydraulic
pump.
 Component is broken.
 Release the pressure in the air-
driven hydraulic pump, disconnect
the oil pipe, and the quick
coupling.
 Release the pressure in the air-
driven hydraulic pump and remove
extra hydraulic fluid.
 Change the broken component.