Product Manual

Page 6 of 11
Assembly Instructions
Refer to the Parts Diagram for the following assembly instructions.
1. Locate the second Base Plate (7) and turn it upside down. Set the second Base Plate (7) onto the
Beams (6). See Figure A.
2. Turn the cart upside down. Attach two Casters (13) with the Swivel Caster Brackets (11) using a
Nut (12) and Axle (14), if necessary. Thread a Carriage Bolt (8) through the Base Plate (7) and
into the Casters (13). Attach one Washer (9) and one Nut (10) for each hole. See Figure B.
3. Attach another two Casters (13) to with the Fixed Caster Brackets (15) using a Nut (12) and Axle
(14), if necessary. Thread a Carriage Bolt (8) through the Base Plate (7) and into the Casters (13).
Attach one Washer (9) and one Nut (10) for each hole. See Figure B.
4. Locate the two Beams (6). Place one on the Platform (4) corner nearest the Handle (1), and place
one on the diagonal corner located on the outside of the Platform (4), as in the assembly diagram.
Make certain that the end with the screw holes is facing upward. Using a rubber mallet, tap the
Beams (6) down into the Platform (4). Note: Position the Beams so that the flange in each
matches the space in the Platform (4). Inserts Screws (5) down through each Beam (6) and into
the Platform (4). See Figure C.
5. Locate another two Beams (6). Place one on the Platform (4) corner nearest the Handle (1), and
place one on the diagonal corner located on the outside of the Platform (4), as in the assembly
diagram. Make certain that the end with the screw holes is facing upward. Using a rubber mallet,
tap the Beams (6) down into the Platform (4). See Figure C.
6. Place the two Swivel Caster Brackets on the same side of the Platform (4) as the Handle (#1).
Place the two Fixed Caster Brackets on the other side of the Platform (4).
7. Place one Platform (4) upside down on the work surface. Locate the Handle (1). Attach the
Handle (1) with Platform (4) using Screw (2 & 3). Making certain that both Trays are facing the
same way. See Figure D.
8. Turn the cart upright. Make certain that all hardware is tight. Make certain that the Fixed Casters
and Swivel Casters roll properly.