Product Manual

Page 7 of 13
(5), hex connector (6), knuckle (11), gooseneck (8), back plate (9), and gasket (10). Note: Before
crossing the wire, foist the cotton varnished sleeve (19) into the knuckle to protect the wire.
Refer to the figure for wiring through the knuckle.
3. Place the lamp holder (3) fixture onto the hex connector (6). Rotate the knuckle (11) to the hex
connector (6). Rotate gooseneck (8) to the other end of knuckle (11). Seat other end of gooseneck
into the back plate (9). Then rotate set screws (15) in back plate to attach the gooseneck (8) in
place. Note: wrap each of the threads with PTFE thread seal tape (20).
4. Adjust the shade to the appropriate angle by knuckle, then tightening screw on the knuckle.
5. Attach the ballast black wire to the supply black wire and the ballast white wire to supply white wire,
using wire nuts (21) provided.
6. Connect green fixture wire to grounding screw in the junction box.
7. Attach the back plate (9) and gasket (10) to junction box by #8-32 screws (16).
(You can also use tapping screws (17) and wall plugs (18) for attaching.)