Manualshelf

Product Manual

ManualsBrandsStrongway ManualsBins + Racks14-Tier Single Side Wire Shelving Unit with 117 Bins — 39.5in.L x 16in.W x 68.5in.H
12345678910
Page 5 of 10
⚠CAUTION
STORAGE RACK USE AND CARE
Do not force the storage rack. Products are safer and do a better job when used in the manner for
which they are designed. Plan your work, and use the correct product for the job.
Check for damaged parts before each use. Carefully check that the storage rack will operate
properly and perform its intended function. Replace damaged or worn parts immediately. Never
operate the storage rack with a damaged part.
Store the storage rack when it is not in use. Store it in a dry, secure place out of the reach of
children. Inspect the product for good working condition prior to storage and before re-use.
Use only accessories that are recommended by the manufacturer for use with your storage rack.
Accessories that may be suitable for one product may create a risk of injury when used with
another product.
Specific Operation Warnings
⚠WARNING
Do not lean, pull, or hang items on rack. Tipping may occur resulting in personal injury.
Do not exceed the rated load capacity of each bin, shelf, or the rack as whole.
Be sure to evenly distribute loads. Concentrating loads may cause the storage rack to fail,
causing property damage or personal injury.
Do not climb on the storage rack. The rack may tip over causing personal injury.
Be sure storage rack is secured to wall at all times.
When using the back stop feature on the bin to pull out the bin and hang on rack, do not pull out
more than one row of bins at a time. Tipping may occur, resulting in personal injury or property
damage.
Do not allow children to play on or near the rack.
Assembly Instructions
For easiest assembly, do not attach the TOP (B) and BOTTOM (C) POLES until Step 5. Once
connected, these will be the posts for the rack. Each POLE (B+C) has slight horizontal line
indentations at each shelf position. Each SLIP SLEEVE (D) has raised horizontal lines inside designed
to lock them in place on the POLE (B+C).
STEP 1
On each BOTTOM POLE (C), place 1 pair of SLIP SLEEVES (E)
at the lowest position. BASE (D) end should be pointed down.
Make sure the arrows on SLIP SLEEVES (E) face up and that
the word ‘TOP’ is right-side up.
Slide the pair of SLIP SLEEVES (E) until you hear a click to
confirm the pair is locked onto the BOTTOM POLE (C). DO NOT
place more than one pair on each BOTTOM POLE (C) at a time.
Note: There will be a very small gap in-between the SLIP
SLEEVES (E)—this is normal.