Operation Manual

39
Setup
ENGLISH
www.strongsat.com
Checking the signal quality
You use this screen to confirm that your set-top box is receiving a
satellite signal on all the LNBs/LNB positions available to it.
To check the signal:
1. On the Signal Settings menu, highlight ‘Signal Quality’, then press
OK.
The Signal Quality screen displays:
The details on the screen show the name of the satellite, together with
bars showing the strength and quality of the signal being received from
this satellite.
Your set-top box must receive both a signal strength and a signal quality
of about 60% in order to successfully find channels. That is, the signal
strength and signal quality bars should both be about two thirds full.
2. Press L or R to change which LNB index details are displayed.
3. Check that your set-top box is receiving an adequate signal on
each LNB index that is being used.
For example, if you have a single LNB, this will be LNB index 1,
but if you are using a DiSEqC™ unit* to connect to more than
one LNB, then each LNB index is associated with the port of
the same number on your DiSEqC™ unit.
4. When you are satisfied that there is an adequate signal, press
back to redisplay the Signal Settings menu.
*DiSEqC™ is a trademark of Eutelsat.