Operation Manual

38
Setup
www.strongsat.com
Changing the antenna configuration
This is the number of LNBs available in your dish installation. If you
change your satellite dish installation, you may need to change this
setting so that your set-top box can tune to all the satellites available.
To change the Antenna Configuration:
1. On the Signal Settings menu, highlight ‘Antenna Configuration’,
then press OK.
The Antenna Configuration menu displays.
2. Highlight ‘Number of LNBs’, then press L or R to select the
number of LNBs you have in your set-up.
3. Highlight ‘LNB index’, then press L or R to select the LNB
index you want to change. If you are using a single fixed LNB,
this will be LNB index 1.
4. Highlight ‘Satellite’ then select the satellite that you want that
LNB to direct towards.
◆ If you are using a single fixed LNB, press L or R to select
the satellite that your LNB is set-up for. Then go to step 6.
◆ If you are using a DiSEqC™ unit*, select the correct satellite
for the LNB connected to each port. LNB Index 1 is
associated with port 1, and so on.
5. Repeat steps 3 and 4 to select an LNB index for each of the
ports on your DiSEqC™ unit.
6. To save the changes, press OK.
7. If you have changed your antenna configuration must then
check the signal quality (see page 39) and search for the new
channels (see page 40).
*DiSEqC™ is a trademark of Eutelsat.