Operation Manual

21
Installation
ENGLISH
www.strongsat.com
A progress screen displays to confirm that the search is taking place.
When the search is complete, a screen displays to tell you the number
of TV and radio channels that your set-top box has found.
5. To confirm these channels and display the next screen, press
OK. Then see ‘Activating your subscription’ on page 22.
Manual set-up
1. Press L or R to change which LNB index details are displayed.
2. Check that your set-top box is receiving an adequate signal on
the satellites that you selected for each LNB index.
If there is no signal, check your installation. Check all the connections
are properly made. See also the section ‘Solving problems’ on page 43.
3. When you are satisfied that there is an adequate signal, press
OK. The Manual Search screen displays.
The ‘Satellite’ line shows the satellite you selected as LNB index 1, and
the details below show the search settings for that satellite.
If you have more that one LNB, you can view the details for each
satellite by highlighting the ‘Satellite’ line then pressing L or R.
You should not need to change the settings, as your set-top box is
preset with the correct settings to receive the best channel line-up. If
you use the preset settings, you can still search other frequencies at a
later date (see page 41).
4. If you do not want to change any search settings, go straight to
step 8.
5. If you want to change the search settings, first highlight the
‘Satellite’ line, then press L or R to select a satellite.
6. Press U or D to highlight each item you want to change, then
use the number buttons or L and R to enter the values you
want.
7. Repeat steps 5 and 6 to change the details for each satellite.