Operation Manual

20
Installation
www.strongsat.com
Checking the signal and searching for channels
The Signal Quality screen is now displayed. You use this screen to
confirm that your set-top box is receiving a satellite signal.
The details on the screen show the name of the satellite, together with
bars showing the strength and quality of the signal being received from
this satellite.
Your set-top box must receive both a signal strength and a signal quality
of about 60% in order to successfully find channels.
Follow the instructions for ‘Automatic set-up’ below or ‘Manual set-up’
on page 21, depending on which set-up you have chosen.
Automatic set-up
Your set-top box is preset in the factory with the correct LNB settings
to receive signals from up to two satellites.
1. Press L or R to change which LNB index details are displayed.
2. Check that your set-top box is receiving an adequate signal
according to the table below.
If there is no signal, check your installation. Check all the connections
are properly made. See also the section ‘Solving problems’ on page 43.
3. When you are satisfied that there is an adequate signal, press
OK.
The Channel Auto-Search screen displays.
4. To start the channel search, press OK.
If you have... Check for adequate signal strength
and quality on...
A single, fixed, universal LNB Index 2, Sirius
Two, fixed, universal LNBs Index 2, Sirius
And Index 1, Thor