Operation Manual

19
Installation
ENGLISH
www.strongsat.com
Setting the antenna configuration and choosing a satellite
When you select ‘Manual’, the Antenna Configuration screen displays.
1. Press L or R to select the number of LNBs you have in your
set-up.
2. Press D to highlight the ‘LNB Index’ line, then press L or R to
select LNB Index 1.
3. Press D to highlight the ‘Satellite’ line, then:
◆ If you are using a single fixed LNB, press L or R to select
the satellite that your LNB is set-up for. Then press OK and
continue to the section ‘Checking the signal and searching for
channels’ on page 20.
◆ If you are using a DiSEqC™ unit*, select the satellite for the
LNB connected to port 1.
4. Press U to highlight the ‘LNB Index’ line, then press R to select
LNB Index 2.
5. Repeat steps 3 to 4 to select an LNB Index for each of the ports
on your DiSEqC™ unit. Then press OK and continue to the
section ‘Checking the signal and searching for channels’ on
page 20.
*DiSEqC™ is a trademark of Eutelsat.