Operation Manual

16
Installation
www.strongsat.com
❖ Switching on for the first time
When you connect your set-top box to the mains, your set-top box’s
front panel lights go through a start-up sequence. After about 20
seconds, your set-top box is switched on and out of standby, and the
standby light is green.
◆ Make sure your TV is switched on.
If the Countries screen below displays, your TV is ready for digital
satellite channels.
You can now continue the installation by turning to the section ‘Making
the installation settings’ on page 18, but note that if you have a VCR
connected to your set-top box via an RF lead (as in connection
method 1), to be able to record satellite programmes, you may need
to perform RF Tuning for your VCR - see page 17.
If the Countries screen does not display...
If you have connected your set-top box to your TV (and VCR) via
SCART leads, try selecting your TV’s ‘AV input’.
If you have connected your set-top box to your TV (and VCR) via RF
leads only, you need to tune a ‘channel for satellite TV’ (see ‘RF Tuning’
on page 17).