Operation Manual

PART 1 • English
13
English
6.4 Subtitles
In no-menu state, press SUB. Press LEFT/RIGHT to select between teletext and DVB subtitles. Use
UP/DOWN to select subtitles language. Confirm your selection with OK button.
6.5 Information
When you press INFO key twice in the no-menu state, the screen will show you current channel information.
A.1 TROUBLESHOOTING
Before requesting service, please check the table for a possible cause of the problem. Some simple
checks or minor adjustments may restore proper operation. The most common problems are
related to cable connections, please disconnect and connect all cables again. If none of the below
indicated remedies solve the problem, consult your vendor.
Symptom Remedy
Installation
Receiver does not find
channels.
A warnring message
appears on screen:
“Antenna Power
Overloaded”
If you are using a directional aerial, make sure it is directed towards a
digital TV transmitter and positioned correctly
Make sure it is possible to receive digital terrestrial signal in your area
It is advisable to use a standard outdoor aerial, which normally have
better specifications than an indoor one
Check the cable of the aerial
If you cannot solve the problem easily have your aerial and installation
tested by a professional
Please, turn off your receiver and check cable and antenna on a short cut
General
Standby indicator on
front panel does not
light up
Check if power is available at the wall socket. Check if the SCART cable
and antenna cable are correctly connected and the receiver is switched on.
Disconnect these cables, and reconnect them to ensure they are in place
Standby indicator on
front panel is red
Your receiver is in standby, press the power button on your remote
control