Manual

29
Press  to select Zoom Mode and press OK to select.
Optional: Fit/Original Size
Repeat Mode
Press  to select Repeat Mode and press OK to select.
Optional: No Repeat/Repeat All
Interval
Press  to select Ineterval and press OK to select.
(Optional:5S/10S/20S)
Information
Press  to select Information, and press OK to view.
Play List
Press  to select Play List, and press OK to display all available Picture.
10. TROUBLESHOOTING
Before calling a service technician, review following information for possible causes and solutions for the
problem you are experiencing. If the TV does not work properly after checking it, please contact your local
service line or STRONG dealer. Alternatively, you can send a support mail via our website www.strong.tv.
Problem Possible cause and solution
TV do not switch ON 1. Check if wall outlet is functioning
2. Plug another electrical device into the outlet to make sure
it is working or turned on.
The remote control does not work 1. Change the batteries.
2. The batteries are not installed correctly.
3. Main power is not connected.
No picture, normal sound 1. Adjust the brightness and contrast.
2. Broadcasting failure may happen.
3. Tunned to UHD channel, is not supported
Normal picture, no sound 1. Press the volume up button to increase the volume.
2. The volume is set to mute, press [MUTE] to restore the
sound.
4. Change the sound system.
5. Broadcasting failure may happen.
Unorderly ripples on the picture It is usually caused by local interference, such as cars, daylight lamps
and hair driers. Adjust the antenna to minimize the interference.
Snowy dots, blocking and
interference
If the antenna is located in the fringe area of a television signal where
the signal is weak, the picture may be marred by dots, show blocking
or break-ups. When the signal is extremely weak, it may be necessary
to install a special antenna to improve the reception.
1. Adjust the position and orientation of the indoor/outdoor
antenna.
2. Check the connection of the antenna.
3. Fine tune the channel.
4. Try another channel. Broadcasting failure may happen.
Ghost Ghosts are caused by the television signal following two paths. One
is the direct path, the other is reected from tall buildings, hills, or
other objects. Changing the direction or position of the antenna may
improve the reception.