User's Manual

Page 5
4. SENSOR/TRANSMITTER MODULE
Installation
Caution: Qualified personnel must perform the following installation
procedures to ensure that the Sensor/Transmitter Module are
properly installed and undamaged. It does not include any standard
procedures normally required in the process of replacing a tire but
due care should be taken to ensure that the sensors are not
damaged.
Tools Required
• Tire changing equipment
• Tire balancing equipment
• Philip Screwdriver
Figure 2 Sensor Module
Figure 2a – How to Install Sensor Module with Tire Valve
Page 14
Turn Backlight On/Off (S- 5)
For programming backlight setting, refer to the following steps.
1. Backlight On (Permanent On)
2. Backlight Off (Auto)
Step 1
Press [OK] button to enter Backlight programming mode.
Figure 38
Step 2
The default-selected option will blink.
1. To change the selection On-Off press [+] or [-] button.
2. To confirm the selection press [OK] button.
3. The receiver will return back to Programming Main menu
display
Figure 39
Activate Spare Tire On/Off Mode (S- 6)
For programming Spare Tire setting option, refer to the following steps.
1. Spare Tire On (Enable Spare Tire monitoring)
2. Spare Tire Off (Disable Spare Tire monitoring)
Step 1
Press [OK] button to enter the Spare Tire setting Mode.
Figure 40
Step 2
The default-selected option will blink.
4. To change the selection On-Off press [+] or [-] button.
5. To confirm the selection press [OK] button.
6. The receiver will return back to Programming Main menu
display
Figure 41