User's Manual

Page 9
6. PROGRAMMING
Figure 20
 To Enter Programming mode Main Menu
1. Ensure that the power is switched ON
2. Press and hold [M] button for 3 sec or more
 In programming mode toggle the [+] or [-] button for desired programming mode from S-1 to S-6.
 To accept the desired programming mode press [OK] button.
 To Quit
Programming Main menu Display mode, press and hold [M] button for 3sec or more.
Page 10
Display Mode (S- 1)
Press [OK] to enter programming display mode. ‘ror’ or ‘noL’ will blink to indicate that it is ready to accept
changes. Toggle [+] or [-] button to alternate between Rotation Mode and Normal Mode.
Rotation Mode
Each of the tires will be ‘scanned’ for the reading. The rotation will begin
from Front Left tire, followed by Front Right Tire, Rear Right Tire, Rear Left
Tire and the cycle will begin again with the Front Left Tire. This is indicated
by a blinking tire icon.
J
K L
I
Figure 22
Figure 21
Rotation Mode Activated
Normal Mode
In the normal mode, the display will always show information of the tire with
the lowest pressure value. The rotation mode tire symbol will be disabled
indicating the selected mode is normal mode. (Refer to figure 23 & 24)
To view information of other tires, press [T] button.
Figure 24
Figure 23
Normal Mode Activated
Note
Value shown is for reference only.