User's Manual

Recommended Installation for Display/Receiver Module and Bracket
Figure 11
1. Determine the desired location for Display/Receiver
Module. Refer Figure. 12 for possible locations
2. Peel off the film covering the piece of black adhesive
double-sided-tape film on the back of the display
bracket. (Figure 13)
3. Mount the Display Module to the desired location.
(Figure 14)
4. Apply pressure around the Display/Receiver Module
for maximum mounting of the module to the car
windscreen. (Figure 15)
5. If the module did not fix well to the windscreen, take
out the Display module from the bracket. (Figure 16
and Figure 17)
6. Apply pressure around the bracket panel for
maximum mounting of the bracket to the car
windscreen. (Figure 18)
7. Install back the Display/Receiver module to the
bracket. (Figure 19)
Figure 12
Figure 13 Figure 14
Figure 15 Figure 16
Figure 17 Figure 18
Figure 19
Page 8