User's Manual

Programming Manual Threshold Setting
To set to other alert threshold value for pressure and temperature, press and hold [Auto/Manual] button for 1
second twice.
For low pressure alert, the maximum limit is 399kPa (58 psi) while for temperature, the maximum limit is
99ºC (210ºF).
Step 1
Upon entering this mode, the first digit of the tire pressure readout will
blink, indicating that it is ready to accept new input. The value is
changed by pressing the [ + ] button or [ - ] button to change the value.
Note
This mode will terminate automatically if there are no key-button
activities after 10 seconds and will revert back to the original factory
preset value.
캜
Kpa
Step 2
To confirm the selected value, press the [OK] button to save it. The
second digit will blink to indicate that it is ready to accept new input.
캜
Kpa
Step 3
Repeat steps 1 and 2 to adjust the value of other digits on the LCD
display for both pressure and temperature.
캜
Kpa
Note
1. Value shown is for reference only.
2. The setting of Manual Threshold Setting can only be done in kPa (Pressure) and ºC (Temperature).
Refer to Annex 1 for conversion between the units.
3. To return to factory-preset value mode, press [Auto/Manual] button once.
4. To enter manual-preset value mode, press [Auto/Manual] button three times.
ACT-P: Factory Preset
MANUAL: Manual Preset
Page 8