User's Manual

Display/Receiver Module
캜
캟
Psi
Kpa
ACT-P
MANUAL
Temperature in
Fahrenheit.
Temperature in Celsius.
Pressure in kPa.
Pressure in psi.
Front Right Tire
Front Left Tire
Measured Pressure
Readout
Measured Temperature
Readout
Auto mode icon.
Rear Left Tire
Rear Right Tire
Sensor Battery Status.
Manual Mode Icon
Figure 7 LCD Display
Installation
1. Insert the Power Supply Cable connector into Receiver socket, which is located at the top rear. Refer
Figure 8.
2. Connect the other end of the Power Supply Cable to the vehicle +12VDC, Ground and ACC.
RED color wire to vehicle +12V DC,
BLACK color wire vehicle Ground,
ORANGE color Wire to vehicle ACC,
Orange
Red
Black
Module
TPMS
Battery
Ignition
Figure 8 Wiring Diagram
3. Peel off the film covering the 2 pieces of adhesive double-sided-tape film on the back of the
display/receiver module.
4. Determine the desired location for Display/Receiver Module. Refer Figure. 10 for possible locations.
5. Apply pressure around the Display/Receiver Module panel for maximum mounting of the module to
the car windscreen.
Figure 9 Connection of Power Cable
Figure 10 Possible mounting positions
Page 7