User's Manual

7. Troubleshooting Guide
Symptoms Possible cause(s) Solution
No display on LCD panel. No power. Check connections of Power cable
at both ends. Ensure that the
connection is on the correct polarity
and properly grounded.
No display on LCD panel. Faulty Unit. Contact your dealer for a
replacement.
The unit does not activate
when the POWER key button
is pressed.
The car ignition has not
been turned ON.
Turn the ignition key to ACC
position.
The receiver is not learning the
ID during ID LEARNING
Mode.
Localize RF interference. Move to another location and re-
initiate the ID LEARNING process.
No instant alert Reverse power cable
installation.
Ensure that the red wire is
connected to permanent power
supply (battery) and orange wire is
connected to ACC position of the
ignition.
8. Appendix
Glossary
Cold Pressure Recommended inflation pressure of a tire at ambient temperature
of 22°C by vehicle manufacturers.
Low Pressure Alert Visual and audible warning that is activated when the tire’s
pressure goes below the preset level.
Display/Receiver Module The electronic module mounted inside the vehicle that alerts the
driver of any tire irregularities.
Sensor/Transmitter Module The electronic module mounted on the wheels that measure the
air pressure and temperature of the tire.
Page 12