User's Manual

Sensor ID Learning Mode (Replacing Display Module or Sensor)
For programming of a new receiver unit or replacement of defective
sensors, refer to the following steps.
Figure 11
Step 1
Turn on the display module. Press [ID] button and [OK] button
simultaneously for 1 second to enter Sensor ID Learning Mode.
The blinking (once per second) of the tire icon, indicates that it is
ready to accept new Sensor ID input.
Select the tire that requires replacement of sensor by pressing the
selected tire icon on the LCD display.
Step 2
Press the micro switch on the new sensor (refer Figure 11) for 1
second. Upon receiving the new Sensor ID, the tire icon will blink
at a faster rate (twice per second).
Step 3
Press [OK] button to save the new Sensor ID.
Step 4
If all 4 sensors are replaced, upon pressing the [OK] button for the
tire, the receiver will revert back to the normal display. This
indicates that the Sensor ID Learning Process is complete.
Note
1. Pressing [ID] button at any time during the learning process will abandon any changes and revert back to
the factory preset.
2. When replacing new display unit, all 4 sensor ID must be re-programmed and saved.
3. The receiver will not save any identical Sensor ID.
Page 11