User's Manual

Sensor ID Exchange Mode
For rotation of tires, the Sensor ID data in the receiver must be changed accordingly to ensure that it
indicates the correct tire when there are any irregularities.
Step 1
Press [ID] button for 1 second or more to enter the Sensor ID
Exchange Mode.
The blinking tire icon and corresponding Sensor ID digit indicates that
it is ready to accept inputs from user.
For this example, assume that we are exchanging the Front Right Tire
with the Rear Right Tire.
Step 2
Press the front right tire button to select it.
This will cause the front right tire icon and its corresponding ID digit to
blink.
Step 3
Use [+] key and [-] key to change the selected Sensor ID digit.
In this case, press [+] twice and follow by the [OK] button to save the
new Sensor ID value.
Step 4
Next, press the rear right tire button to select it.
The Rear Right Tire icon and its corresponding ID digit will blink.
Step 5
Use [ + ] key and [ - ] key to change the selected Sensor ID digit.
In this example, press [ - ] twice and follow by the [OK] button to save
the new Sensor ID value.
To exit this mode without saving, press [ID] button for 1 second and it
will exit Sensor ID Exchange Mode.
Step 6
The receiver will revert back to normal display and that complete the
process of exchanging Sensor ID data in the receiver.
ACT-P
캜
Kpa
Page 10