User's Manual

EWS-150g Configuration Guide 3
EWS-150g Configuration Guide
Installing the EWS-150g
This User’s Guide is intended for use by Service Providers who are pre-configuring the device for their
subscribers. The physical installation of the EWS-150g is performed by the subscriber. It is the subscriber’s
responsibility to ensure that the unit is connected to their computer or home network properly, using the
components provided. The following items are shipped in the product’s carton:
◗ 1 x Strix EWS-150g unit
◗ 1 x Ethernet cable, 5ft length (blue)
◗ 2 x Omni-directional antennas
◗ 1 x Power supply
Factory Default Settings
The following table shows the default settings established at the factory for the EWS-150g.
Resetting the EWS-150g to its Factory Default State
To reset the EWS-150g to its factory default state, use a paper clip—or other similar tool—to press the Reset
button (see Figure 2) on the rear panel. Hold the Reset button down until the LEDs on the front panel go OFF
and the Power (PWR) LED comes ON again (about 5 seconds) to restore all configuration settings to their
factory default values.
Function Factory Default Setting
IP Address 169.254.1.250
User Name Admin
Password Admin
802.11g Radio Enabled, and configured as a wireless client station.
SSID Strix Wireless Network
The EWS-150g will always connect to the Strix Wireless
Network SSID, when available.
DHCP Enabled
Layer 2 NAT Enabled
Accessibility Accessible via the Ethernet port
Manager/One Plug-In Enabled