User's Manual

10 EWS-150g Configuration Guide
EWS-150g Configuration Guide
Setting Up the Radio Parameters
To set up the 802.11g radio parameters, click on the Configure tab then click on Radio Parameters to display
the 802.11g Radio Parameters window.
Figure 10. Radio Parameters Window
1. In the Data Rate field, choose the preferred data rate from the pull-down list. The default for this field
is Best, which means the EWS-150g will select the best data rate available automatically.
2. In the Transmit Power field, choose the preferred transmit power from the pull-down list (either Full,
Half, Quarter, One Eighth, or Minimum). The default for this field is Full, which means the radio is
always operating at full (maximum) power.
3. In the Background Scan Enabled field, check this box to enable background scanning for wireless
client stations. the default for this field is enabled.
4. In the Background Scan Interval field—If you enabled background scanning—enter a value between
1000 and 60000 ms to define the interval (elapsed time) between scans. The default for this field is
5000 milliseconds.
5. In the Background Scan Duration field—If you enabled background scanning—enter a value
between 10 and 10000 ms to define the duration of each scan. The default for this field is 50
milliseconds.
6. In the Fragment Length field, enter a value between 256 and 2346. This setting determines the size of
the wireless frame. Wireless frames are reassembled by the EWS-150g before being forwarded to the
Ethernet port, but only if the frame is smaller than the Ethernet MTU (1536 bytes). The default value
for this field is 2346.