User's Guide

USER GUIDE
Note: When using wireless uplinks between Network Nodes, the Access/One Network
self tuning process requires that a default gateway and/or DNS be specified to determine
delays to the host Ethernet. If DHCP is used throughout the network (default setting),
specifying both of these as part of the options will satisfy this requirement. Otherwise, if
static IP addresses are configured, the default gateway must also be configured to allow
correct operation of the self tuning feature.
• User Name: Enter the user name that is required to access the web server interface
within the Network Server Module. The default value for the User Name is ‘Admin’.
The user name is case sensitive.
• Password: Enter the password that is required to access the web server interface within
the Network Server Module. The default value for the Password is ‘Admin’. The
password is case sensitive. Note: We strongly recommend changing the Admin
password immediately after the initial login to the Access/One Network.
• Confirm: If you typed a new password in the ‘Password’ field, retype the same
password in this field in order to confirm the password change. Note: Performing this
action will permanently change the login password.
• Outdoor Environment: Check this item if the Access/One Network Node is going to
be installed in an environment with uncontrolled temperature. The affected Nodes will
set the appropriate temperature regime and corresponding fan speed to better survive in
these types of environments.
Click the ‘Update’ button at the bottom of the page to save any changes made to the settings in
this page. Click the ‘Apply Configuration’ tab to make the configuration information active in
the Access/One Network cloud.
STATIC NETWORK SERVERS
When your Access/One Network spans multiple IP subnets, it is necessary to enter an IP
address of at least one Network Server Module that resides on each of the other subnets so that
all of the subnets can be managed from within a single Manager/One browser window.
23