Installation Guide

While holding the StringerShield up and in place,
insert the top clip into the closest hole position.
Replace red support bar, washer and nut back in
position prior to removal in step 1 and hand tighten
(FIGURE 2).
If any “play” or movement is found in the space be-
tween the upper and lower clips, use the two small
adjustment screws on the bottom clip to remove
any “play” or movement (FIGURE 3).
NOTE: DO NOT overtighten the adjustment screws. The
adjustment screws should be hand tightened ONLY to
remove any movement up and down.
Tighten the two large nuts found on each clip until
tight and no movement is possible (FIGURE 4).
Tighten the two small locking nuts on each adjust-
ment screw on the lower clip to keep the adjustment
screws in place (FIGURE 5).
Cut 2X4 stud material* to desired length for top and
mid rail. Attach the 2X4’s using the pre-drilled hole
on each 2X4 bracket using a deck screw no longer
than 1-1/2 inch in length (FIGURE 6 ON BACK PAGE).
FIGURE 3
FIGURE 2
FIGURE 4
FIGURE 5
STEP 6 STEP 7
STEP 8
STEP 9
STEP 10