Operation Manual

Step 1: Handlebars assembly

MX800/MX850

Step 2: Racks assembly

Step 3: Compete assembly

FIG-6

FIG-7

FIG-9

FIG-8

1. Flat the shipping box and take out packing material, Styrofoam, parts, screw bag and manual etc. from box.(FIG 1)

2. Remove screws/washers 18 19 20 22 from base frame and screws/washers 21 22 from Right/Left handle bar.(FIG 2)

3. Upright the completed support handles and handlebars.Pls set up handle bar 5 6 with supporting handle 3 4 by

attached 21 22 screw and washer and fix it.(FIG 3)

4. Attach and tighten screw 18 and nut 19 on left support handle. Attach and tighten screw 20 and washer 22 on right

support handle. Repeat the same on right side.(FIG 4)

5. Attach base frame covers 13 and 14 to match cover 12 on left base frame and then tighten with screws 23 24. (FIG 4)

6. Repeat the same on right side for base frame covers 15 16 17 . (FIG 5)

Warning:

1. Be careful to avoid machine tilt or getting hurt.

2. Do not have the wire harness(inside of handlebars) get pinched.

1. Attach and tighten screw and washer 21 22 on

right/left handlebars.

2. Attach left rack 10 on left handlebar and tighten with

screws 23.

3. Repeat the same on right side for right rack

assembly.

FIG-5

1. Attach handle rail on handlebar and then tighten with

screws/washers 21 22. (FIG 8)

2. Adjust console bracket 7 and console to a proper

position and then tighten the 4 pcs of screws 20 22

underneath of handlebar. (FIG 9)

FIG-3