Owners manual

STREET SCENE EQUIPMENT,INC. 950-70727
365 McCormick Avenue 1999 - 2004
Costa Mesa, Ca. 92626 CHEVY SILVERADO
Phone [phone] Fax [phone] &
GMC SIERRA
SMOOTH BED CAPS
INSTALLATION INSTRUCTIONS
NOTE: Fit all parts before painting ( See Special Instructions For Paint Prep. ) Parts that have been
installed, preped, or painted are not returnable.
V
ERY IMPORTANT ! Read and understand all directions and check the following parts list before starting
installation.
PARTS LIST
1 PR. Smooth Bed Caps 1 Instruction Sheet 1 Street Scene Decal
27 FT.
1/2" 2 Sided Tape 1 Urethane Prep Sheet
TOOL LIST
NONE REQUIRED
1. Clean the factory bed rail with alcohol.
2. Clean the back side of the smooth bed caps with alcohol at the areas that the two sided tape will be
applied.
3.
A
pply the two sided tape to the smooth bed caps on the outward edges leave the backing on.
4. Set the smooth bed caps into position starting at the tailgate end. lift the corner of the backing of the two
sided tape and pull off while applying pressure to the caps against the bed.
6/30/03 SSE 950-70727