Owners manual

STREET SCENE EQUIPMENT,INC.

950-70236

365 McCormick Avenue

2010

Costa Mesa, Ca. 92626

CHEVY CAMARO

Phone (714) 426-0590 Fax (714) 426-0591

V-6 / V-8 NON SS

SPLITTER URETHANE

INSTALLATION INSTRUCTIONS

NOTE: Fit all parts before painting ( See Special Instructions For Paint Prep. ) Parts that have been

installed, preped, or painted are not returnable.

NOTE:

Check fit all body parts PRIOR to paint. Follow urethane prep instructions before painting. Take

your time and pre-fit all pieces so that they will have a tight fit to the body.

VERY IMPORTANT !

Read and understand all directions and check the following parts list before starting

installation.

NOTE:

We recommend you install Splitter, Air Ducts, and the Grilles at the same time. That way you only

have to pull the fascia off one time.

PARTS LIST

Front Splitter

Instruction Sheet

# 10 Self Tapping Screws

Urethane Prep Sheet

Tinnerman Nuts

4 FT.

1/2" Two Sided Tape

3 PKGS

3M Adhesion Promoter

TOOL LIST

10MM Socket, Ratchet Torx-20, Flat Blade Screwdriver,

Open hood.

Then you will need to pull the front fascia off to install the Street Scene Spiltter. To do this

after opening the hood across top top of fascia you will need to remove the 10MM bolts and 6 push in

fasteners. Then there are two more bolts on the bottom of fascia. See photos below.

PAGE 1

1/19/10 SSE 950-70236

PAGE 1
STREET SCENE EQUIPMENT,INC. 365 McCormick Avenue Costa Mesa, Ca. 92626 Phone (714) 426-0590 Fax (714) 426-0591 950-70236 2010 CHEVY CAMARO V-6 / V-8 NON SS SPLITTER URETHANE INSTALLATION INSTRUCTIONS NOTE: Fit all parts before painting ( See Special Instructions For Paint Prep. ) Parts that have been installed, preped, or painted are not returnable. NOTE: Check fit all body parts PRIOR to paint. Follow urethane prep instructions before painting.
PAGE 2
. Next on the inside of the wheel well there will be 3 screws on each side. Use a Torx20 to remove. Then pull open slpash guard open. There will be one 7MM bolt and 3 more 10MM bolts. You will have to reach in to remove. See photos below NOTE: One of the screws is on each side of the blinker and the last one is right below the head light. 3. Slide off the front fascia but you will to un-plug the wires for the lights. See photo below. 4.
PAGE 3
5. Placement of two sided tape on the Street Scene Splitter. Tape Here Tape Here Screw Here 6. With the help of another person place your splitter into postiion where the two sided tape is first. Then where the 3 bosses are you will use the screws provided. Install two in the center boss and one in each of the other two bosses. Use the #10 self tapping screw and on the other side use the tinnerman nut to tighten. 7.