Installation Manual

Prior to installing the appliance, plug the power cord into a working electrical outlet and test the
various functions of the unit. Ensure that the fan is functional on all speeds and that the lights
operate normally before proceeding with installation.
To mount the range hood, follow the below steps.
Step 4
For ducted installation only. For ductless installation, skip this step.
Refer to Figure D to determine your appropriate ducting method. If venting the unit into the upper cabinets,
use a screwdriver to remove the vertical knockout plate. If venting the unit into the wall, remove the horizontal
knockout plate.
Step 2
Face the underside of the hood and identify the damper/duct connector located to the left of the fan wheel
(Figure B).
Remove the 3 screws holding the connector to the hood. Then, remove the damper/duct connector from
inside the hood and set it aside.
Step 1
The recommended distance between the range hood and the cooking surface is 26 to 28 inches. (Figure A)
Prepare the hood for installation by removing the filters and setting them aside for later.
Step 3
For ducted installation only. For ductless installation, skip this step.
Remove the 3 screws holding the baffle to the hood and set them aside. Then,slide the baffle out of the slot (Figure C).
Rotate the baffle and insert it long-side down into the slot as shown in Figure C. Secure the baffle to the slot
with the same 3 screws.
26"-28"
DAMPER /
DUCT
CONNECTOR
SCREWS
3¼" X 10"
VERTICAL
KNOCKOUT
PLATE
3¼" X 10"
HORIZONTAL
KNOCKOUT
PLATE
BAFFLE
SLOT
BAFFLE
SLOT
Figure A
Figure D
Figure B
Figure C
— 3 —
— 4 —