DROP-IN BATHTUB SERIES OWNER'S MANUAL & INSTALLATION GUIDE READ ENTIRE INSTALLATION GUIDE PRIOR TO INSTALLING THE BATHTUB THIS BATHTUB SHOULD ONLY BE INSTALLED BY A CERTIFIED PLUMBER CAUTION! TWO PEOPLE ARE REQUIRED TO LIFT THE BATHTUB QUESTIONS ON PRODUCT, INSTALLATION, RETURNS? PLEASE CONTACT streamlinebath.com support@streamlinebath.
WARRANTY RETURNS We thank you for your purchase. Here at Streamline®, our goal is to provide customers with exceptional bathroom and kitchen products. We understand that things sometimes don’t work out. If you are unsatisfied with your Streamline® product and would like to initiate a return, please reach out to support@streamlinebath.com .
PRIOR TO INSTALLING These products must be installed by a fully insured and licensed plumber only. Installation of any product by anyone other than fully insured and licensed plumber shall void limited warranty. We are not responsible for any local code compliance for this product. Building and plumbing codes may vary state-to-state. Streamline shall not be held liable for any and all incidental damages or flood caused due to use of this product.
DRAIN MODEL COMPATIBILITY FREESTANDING BATHTUB R-5520-67CIDIWH R-5540-71CIDIWH R-5560-59CIDIWH R-5561-63CIDIWH R-5562-67CIDIWH R-5580-59CIDIWH R-5581-63CIDIWH R-5582-67CIDIWH R-5600-59CIDIWH R-5601-67CIDIWH R-5620-59CIDIWH R-5621-67CIDIWH R-5622-71CIDIWH R-5640-67CIDIWH R-5660-59CIDIWH R-5661-67CIDIWH R-5662-71CIDIWH N-DWF-CH N-DWF-GLD
DRAIN DIAGRAM No Model: N-DWF-GLD Model: N-DWF-CH ITEM Qty 1 Cover 1 2 Cover gasket 1 3 Cartridge 1 4 Strainer 1 5 Waste upper gasket 1 6 Waste lower gasket 1 7 Connector 1 8 Coupling nut 1 9 Nut 1 10 Washer 3 11 Tee 3 12 Pipe 1 13 Overflow body 1 14 Tapered rubber gasket 1 15 Overflow upper gasket 1 16 Overflow plate 1 17 Pin Bolt 1 16 Taic piece 1 17 Flange 1 LEVELING FOOT DIAGRAM No.
BATHTUB INSTALLATION 1. Prepare the site where the bath will be installed by waterproofing the floor and determining the location of the drain pipe. Please refer to pictures 1, 2, 3 for recommended methods of installation for this bathtub model. 2. Take (1) adjustable foot [#5] and (1) nut [#3] and screw the nut halfway on foot. 3. Screw the adjustable foot with the nut into the leveling foot. 4. Take (1) retaining screw [#1] and put it through the hole at the top of the foot.
6. Ensure to mark all positions of leveling legs on the floor using a pencil. Move the bathtub into the desired location near the drainpipe. 7. Take the strainer, place silicone sealant around it, and then place it into the drain hole ensuring a tight connection with the drain ell & gasket. Use silicone sealant. DO NOT use plumbers putty to seal. Silicone Sealant Strainer Gasket Drain Ell 8. Insert the tailpiece into the trap inlet using the O-ring, coupling nut, & flange.
9. Assemble the tee section to the tailpiece, overflow, & drain ell using the coupling nuts and O-rings that are provided. Tee Overflow Ell O Ring Coupling Nut 10 . Attach the tapered rubber gasket to the overflow ell. Align the overflow ell with the overflow hole & secure the drain to the tub with overflow plate and screw provided. Tapered Rubber Gasket Overflow Plate 11 . Run water into the bath and check the bath drain connections for leaks.
