Installation Guide

h) Check to ensure that the clawfoot is aligned
properly with the bathtub and is sitting snug
against the bathtub.
Once this is done, use a wrench to tighten all
of the nuts.
h) Take (1) washer [#5] and place it over the bolt
on the metal plate. Then take (1) nut with washer
[#6] and screw it into the bolt. Do not tighten.
Repeat the same step for the lower bolt. Once
this is done, use a wrench to tighten all of the nuts.
i) Repeat the same procedure for the other 3 legs. i) Repeat the same procedure for the other 3 legs.
The following drain installation is applicable to drain models N-DWF-CH & N-DWF-GLD. Please skip to
step 12 for drain model A-1840-0.
7. Take the strainer, place silicone sealant around it, and then place it into the drain hole ensuring
a tight connection with the drain ell & gasket. Use silicone sealant. DO NOT use plumbers putty to seal.
Silicone
Sealant
Strainer
Gasket
Drain Ell
8. Insert the tailpiece into the trap inlet using the O-ring, coupling nut, & flange. The tailpiece may
need to be cut for proper fit. 1''-2'' of the tail piece shoudl fit inside the trap. Slip the flange over the tailpiece
and slide down to the floor.
O Ring
Coupling Nut
Flange
Trap Inlet
Tailpiece