Installation Guide

streamlinebath.com
[e-mail] [phone]
If deep cleaning is necessary, rinse or soak the
tub in warm water for 30 minutes and add a bit
of liquid soap or dish soap to the water. Rinse
and dry with a soft towel.
It is advised to clean the surface of the bath
regularly in order to remove any insoluble
products. Warm soapy water should be used
and afterwards the bath should be wiped. Do
not let cleaners soak in.
It is advised to always run some cold water
before turning on the hot tap, with hot water
temperatures not exceeding 65 Celsius.
If deep scratches or burns appear, please use
sandpaper with at least 1500 grit. Dampen the
sandpaper slightly with water and then proceed
to rub the sandpaper in a circular motion around
the affected area, ensuring that you rub slightly
wider than the affected area.
Continue doing so until the scratch is no longer
visible. In order to bring the affected area back to
its shiny form, please use a soft cloth and a small
amount of polish to buff the rubbed area.
Continue doing so until the affected area is
restored to its original shine.
35