Installation Guide

Attach the strainer upper gasket (Q) to the strainer (C). Spread silicone sealant
(not included) along the underside flange of the strainer (C). Align the drain
elbow (D) and the rubber drain washer (E) from underneath the bathtub drain
hole. Insert the strainer (C) into the drain hole and securely attach it from
underneath the bathtub to the rubber drain washer (E) and to the drain
elbow (D). Use pliers or a strainer wrench (not included) to tighten it.
. Position a slip nut (G) and washer (H) onto the drain elbow (D), orienting the
threads of the slip nut and the beveled edge of the washer toward the end of
the tube.
Slide a slip nut (G) and washer (H) onto the overflow elbow (A), ensuring that
the threads of the slip nut and the beveled edge of the washer are oriented
toward the end of the tube.
Next, position the rubber overflow washer (B) onto the overflow elbow (A),
with the thicker lip facing the overflow elbow’s upper part, as indicated in the
drawing.
Insert the longer arm of the retainer clips (Y) into the slots located just below
the screw holes on the overflow elbow (A).
Installation Instructions
streamlinebath.com
[e-mail] [phone]
29
8. If the extension tube (N) is unnecessary, refrain from using it. Instead, insert the
overflow elbow (A) into the waste tee (F) and gently tighten the slip nut (G)
without over-tightening.
Please note that the extension tube (N) can be cut if necessary to fit the
bathtub properly.
9. Position the overflow elbow (A) over the overflow hole from the bathtub's
exterior.
If the extension tube (N) is needed for the desired overflow height, insert the
overflow elbow (A) into the extension tube (N), and carefully tighten the slip nut (G)
without over-tightening. Then, position a slip nut (G) and washer (H) on the
extension tube (N), orienting the threads of the slip nut and the beveled edge of the
washer toward the end of the tube. Insert the extension tube (N) into the waste tee
(F) and gently tighten the slip nut (G) without over-tightening.
Measure from the center of the overflow hole to the bottom of the bathtub,
where the drain elbow (D) will connect to the waste tee (F). Determine if the
extension tube (N) is needed based on the measured height.