Installation Guide

1
2
1
Step 2 Checking and testing
Step 1 Faucet installation
1
2
Step 3 Maintenance
B.If faucet leaks from the handle or drips from spout, please replace cartridge following the following steps:
3
4
5
80MM
1
Hot water
Cold water
Drill one hole of 130mmX130mm max and
drill 3 holes with 80mm diameter as shown.
Align the base① with the holes exactly as
shown.
Insert the expansion anchors① into the holes
on the base② with a hammer,tighten with
adjustable wrench.
1
2
2
Check all connections at arrows for leaks,
re-tighten it if necessary.
BUT DON'T OVERTIGHTEN
Remove aerator by coin and open the
hot and cold water supplies. Check for
leaks. Turn on faucet handle for one
minute to flush debris from faucet.
1
A.If there is splash or low flow rate,please remove the aerator with by coin and clean the debris.
1 2 3
Hot water
Cold water
Connect hot and cold supply lines and test by
opening water lines.
If there are no leaks, remove the 3 screws (1)
with the Allen key (2), then remove plate (3)
and nuts (4) as shown.
1
2
3
4
6
7
Connect hot water flexible hose(1) and cold
water flexible hose(1) to the base (2) correctly
as shown.
1
2
Insert 3 screws (1) into holes on the plate(2),
tighten with allen key(3).
1
2
3
Disassemble the screw② with
allenkey①, take out the handle③,
then remove the trim cap④.
1
2
3
4
Unscrew the cartridge nut① with
adjustable wrench, then take out
the old cartridge②.
Place a new cartridge in the cartridge
seat, then screw the cartridge lock nut
and assemble the handle by securing
the screws.Repeat the above steps for
the other cartridge if necessary.