Installation Guide

8
Setup & Installation
Pipe Cut Out Table
5. If installing a Control with SharkBite connections refer to the
pipe cut out table below. If installing a Control with FNPT
connections, thread your adapters (not included) onto the
unions and measure the cutout length.
6. Cut and remove pipe section. Ensure the pipe is cut clean,
square, and is free from any dirt or debris.
Pipe Size
SharkBite Pipe Cut Out
Section
3/4 in. 8.5 in.
1 in. 10 in.
1-1/4 in. 10 in.