Installation Guide

11
Making a SharkBite Connection
1. Check that ttings and pipe are clean, in good condition and
are free from damage and foreign objects. Also check that the
pipe is free from scratches, cuts, or gouges.
2. Cut the pipe so that the ends are square. Ensure that there are
no burrs or damage to the cut end.
3. Once the pipe end is cut square and clean, use the SharkBite
Depth Deburr Gauge (sold separately) and a permanent
marker to mark the insert depth on the outside of the pipe.
(see chart below)
4. Insert the pipe through the release collar to rest against the
grab ring.
5. Push the pipe rmly with a slight twisting action until it
reaches the tube stop, To ensure that the pipe is correctly
inserted, check that the depth mark is by the release collar.
Pipe Size Insertion Depth
3/4 in. 1-1/8 in.
1 in. 1-3/8 in.
1-1/4 in. 1-7/8 in.