User's Manual

AD Plus2.0 User Manual
Page 30 of 66
1. DHCP Mode: indicates that the device automatically obtains the IP address.
After it is selected, the network automatically allocates a dynamic IP address,
and the DNS address can be dynamically or statically customized.
2. Static IP: indicates that the device uses the static IP address. If the preset static
IP address is used, the DNS address must be specified statically.
3. Direct Port: Set to 80 by default. This port will be used for IE access.
WIFI
Tap Preferences > Basic Setup > Network > WIFI, as shown in the following
figure:
1. Lock: enables/disables the modification of Wi-Fi hotspot parameters. After it
is selected, the relevant parameters of the Wi-Fi hotspot will not be modified.
2. Enable: specifies the Wi-Fi connection mode and can be set to AP, Client or
Disable.
 AP: In this mode, the Wi-Fi name is automatically associated with the
vehicle license plate number. You can cannot change it or set a password
for it on this screen. Moreover, the device maintains the hotspot status
during and after the startup. (If the AD Plus2.0 has the AP mode switch