User's Manual

AD Plus2.0 User Manual
Page 65 of 66
2.9.6. Algorithm Calibration
On the algorithm calibration screen of AI alarms, set the algorithms used by the
camera channels.
Tap Preferences > Alarm > AI App > Algorithm Calibration, as shown in the
following figure.
When the Road Facing Camera is used for advanced assistant driving, the usage of
the 1-channel algorithm needs to be set to ADAS, and the mode type needs to be set
to normal mode
When the Cabin Facing Camera is used for the intelligent cockpit, the 2-channel
algorithm needs to be set to DSC, and the mode type needs to be set to normal mode
When the AHD port is connected to a 1-channel DMS camera and used for driving
status detection, the 3-channel algorithm needs to be set to DMS, and the mode type
needs to be set to normal mode
Note: In the current status, the AD Plus2.0 only supports simultaneous operations of
two AI algorithms, that is, ADAS+DSC, ADAS+DMS (either DSC or DMS), or
ADAS+BSD. Please be noted that currently, simultaneous operations of three
algorithms are not supported.