User's Manual

AD Plus2.0 User Manual
Page 63 of 66
 No Driver
Tap Preferences > Alarm > AI App > DMS/DSC. Enable No Driver alarm. On the
alarm triggering setting screen, tap Setup, as shown in the following figure:
No Driver alarms have only one level. When a No Driver alarm is triggered, there
is a voice prompt. The alarmed speed can be customized and is defaulted to 20 km/h.
Other parameters are the same as those of HWM and are not described here.
In the AI function, BSD alarm is supported. Choose Preferences > Alarm > AI
App> BSD. The following screen is displayed, where you can set the relevant
parameters of the BSD alarm. The BSD alarm does not distinguish Level I and
Level II alarms by the speed range, but according to the distance between the
pedestrian and the vehicle, as follows:
Level I alarm: 2 - 3 m distance from the vehicle body
Level II alarm: 1 - 2 m distance from the vehicle body
Level III alarm: 0 - 1 m distance from the vehicle body
Collision warning: 2 m in front of the vehicle body