User's Manual

AD Plus2.0 User Manual
Page 58 of 66
Calibration failure status judgment:
Manual calibration: After the manual calibration is saved, the detected values on the
X, Y, and Z axes are not (0, 0, 1). As manual calibration forcibly sets the values to
(0, 0, 1), there are almost no manual calibration failures.
Automatic calibration: Automatic calibration is a continuous process. Therefore, the
calibration status abnormality, time, and real-time values on the X, Y, and Z axes
are recorded when the deviation of values on the X, Y, and Z axes are detected to be
within ±0.1 from (0, 0, 1) for 5 consecutive times of calibration
6. Installation Angle specifies the angles of the installed device.
7. Pass-through of 100 Hz G-sensor data is supported. Select or deselect to enable
or disable this function.
8. Integrated navigation: when the device is connected to the inertial navigation
module that supports vehicle attitude detection, this enabling is displayed on
the screen. Since the vehicle attitude output by the inertial navigation module
is more accurate than the attitude events calculated by pure three-axis/six-axis,
this function is used to determine sudden acceleration, sudden deceleration,
sharp left/right turning, acceleration, deceleration, turning, and vibration events.
When the function is enabled, the device can detect these events through
inertial navigation. However, the accuracy cannot be guaranteed for now.
On the Geo-Fence screen, you can set the processing strategies for fence entry/exit
and paths. This function must co-work with the CEIBA2 or FT Cloud platform.
2.9.4. AI Alarm
You can set AI alarm parameters by using the EasyCheck App. Tap Preferences >
Alarm > AI App to enter the AI alarm setting screen. Supported AI alarms are
shown below.
ADAS Alarm LDW, FCW, HMW, and PCW
DMS/DSC
Alarm
Driver Fatigue, No driver, Handheld Devices, Smoking, Distraction, Yawn, Seatbelt,
No Mask, and Infrared Block Alarm (the red bold letters indicate the currently supported
alarm types)
DSC functions supported in V1.3 include Handheld Devices and Seatbelt;
DMS functions supported in V1.3 include Driver Fatigue, No driver, Handheld
Devices, Smoking, Distraction, Yawn, Seatbelt, and No Mask.
The parameter settings of all AI alarms share the same logic. The trigger conditions