User's Manual

AD Plus2.0 User Manual
Page 55 of 66

Privacy Mode
The privacy mode trigger and release mode can be set on the privacy mode setting
screen. Click Preferences > Alarm > Video > Privacy Mode. The screen is
displayed, as shown in the following figure:
Click the Settings button to enter the following screen, where you can set the
privacy channel, privacy mode trigger mode, privacy mode release mode, and
privacy mode voice enabling.
Privacy channel: when the privacy mode of a channel is turned on, it means that the
audio and video recording of this channel is turned off, and it is enabled after turned
on;
Privacy mode trigger mode: by IO or ACC, which are optional. After the IO usage
is configured, the IO can be triggered to realize privacy mode on/off. Refer to
Section 2.9.1 for the specific setting method of IO. The ACC trigger mode means
that the privacy mode (stopping audio and video recording) is turned on after the
ACC is turned off for 10s.
Privacy mode release method: there are two methods--by speed or by IO, and either
of which must be selected. The setting and usage of IO are consistent with the
trigger mode. As long as the IO is set, it can be used for triggering and releasing.
Speed mode means that, when the privacy mode is enabled, the privacy mode can
be released if the vehicle speed is greater than a certain value.