User's Manual

AD Plus2.0 User Manual
Page 54 of 66
 Camera cover
You can configure parameters for the camera cover alarm in the Cover screen.
Choose Preferences > Alarm > Video > Cover. The Cover screen is displayed, as
shown in the following figure:
Tap Setup under Trigger to open the following screen. You can configure the
channel, sensitivity, duration time, valid time, and speed threshold for the camera
cover alarm. In the AI channel, the algorithms are used for detection. In the non-AI
channel, the MDVR is used for judgment. Alarm linkage parameters can be set in
the same way as for IO Alarm.
The camera cover alarm of the ADAS channel is triggered when the vehicle speed
exceeds 10 km/h and the duration of covering lasts for 15s. The cover alarm of the
DMS channel is triggered when the duration of covering lasts for 5s, and the speed
exceeds the set speed value on the cover alarm screen. The cover alarm of the DSC
channel is triggered when the duration of covering lasts for 6s, and the speed
exceeds the set speed value on the cover alarm screen. The cover alarm of the BSD
algorithm is triggered when the duration of covering lasts for 8 min and the speed
exceeds 0. At present, the front top view BSD does not support the cover alarm.