User's Manual

AD Plus2.0 User Manual
Page 51 of 66
superimposition.
4. Alarm Type: Alarm or Event

When Alarm Type is Alarm:
1) Alarms are superimposed on the preview and recording screen.
2) Alarms are uploaded to the platform.
3) Alarm logs are write-accessible.

When Alarm Type is Event:
1) OSD superimposition does not apply.
2) Alarms are not uploaded to the platform.
3) Write an alarm log.
5. Sensor Uses: Set the purpose of the IO, which can be Left Steering, Right
Steering, Brake, and Privacy.
6. Trigger: Tap Setup to enter the screen shown below:
1) Trigger Source: High/Low level or Pulse. High level by default.
2) Effective Time: a time period during which a cleared alarm is reported
again. Alarms generated in this period are considered the same. Value
range: 0-10s. Default value: 5s
Assume that a motion detection alarm is generated at 13:23:30 and is cleared at
13:23:50. If Effective Time is set to 10 seconds and the motion detection
alarm is generated within 10 seconds, the two motion detection alarms are
considered to be the same one. The alarm log records one alarm and alarm
linkage stops only after subsequent motion detection is canceled.
7. Linkage: Set service functions to be linked with the alarm. Tap to enter the
screen shown below.