User's Manual

AD Plus2.0 User Manual
Page 44 of 66
 When Pulse is selected, the screen is shown as below:
Where
3. Calibration Mode: Select Input Manually or Input Automatically.

When Input Automatically is selected, tap Correct to proceed with the
calibration.

Select Input Manually:
1) You need to input manually the initial mileage of the odometer and the system
will calculate it accordingly;
2) Click Start; (MCU will automatically record the number of pulses)
3) When you click to end learning, you record the driving mileage of the
odometer again to calculate the mileage difference;
4) Then you input the mileage difference and click Calculate, and the pulse
coefficient will automatically display the calculation result; (the calculation
result unit is consistent with the speed unit)